Position:Home > Steel > Alloy Steel

SAE 6150

 We are professional AISI 6150 SAE 6150 Forged forging Steel Round Bars Rods Square rectangular rectangle Flat Hex Bars Forged shafts,AISI 6150 SAE 6150 Forged Forging Steel Hollow Bars Forged Forging Sleeves Bushes Bushing Pipes Piping tube tubings barrels Casing Cases Shells cylinders hubs housings,AISI 6150 SAE 6150 Seamless Rolled Steel Rings,AISI 6150 SAE 6150 Forged Forging Steel Slewing Bearing rings,AISI 6150 SAE 6150 Forged Forging Steel Blocks Discs Disks Plates,AISI 6150 SAE 6150 Forged Forging Steel Gear Shafts Pinion Shafts Spindles,and other AISI 6150 SAE 6150 forged forging parts Forged Products forged forging pieces forged forging steel components materials  from china

 

Chemical Composition

The chemical composition of AISI 6150 SAE 6150 alloy steel is listed in the following table.

Element Content (%)
Iron, Fe 97.095 - 97.72
Chromium, Cr 0.800 - 1.10
Manganese, Mn 0.7 - 0.9
Carbon, C 0.480 - 0.530
Silicon, Si 0.150 - 0.3
Vanadium, V ≥ 0.150
Sulfur, S ≤ 0.04
Phosphorous, P ≤ 0.0350

Physical Properties

The following table shows the physical properties of AISI 6150 SAE 6150alloy steel.

Properties Metric Imperial
Density 7.85 g/cm3 0.284 lb/in³

Mechanical Properties

The mechanical properties of AISI 6150 alloy steel are outlined in the following table.

Properties Metric Imperial
Tensile strength, ultimate 670 MPa 97200 psi
Tensile strength, yield 415 MPa 60200 psi
Izod impact 27 J 19.9 ft-lb
Modulus of elasticity 190-210 GPa 27557-30458 ksi
Shear modulus (typical for steel) 80 GPa 11600 ksi
Bulk modulus (typical for steel) 140 GPa 20300 ksi
Poissons ratio (calculated) 0.27 – 0.30 0.27-0.30
Elongation at break (in 50 mm) 23% 23%
Hardness, Brinell 197 197
Hardness, Vickers (converted from Brinell hardness) 207 207
Hardness, Knoop (converted from Brinell hardness) 219 219
Hardness, Rockwell B (converted from Brinell hardness) 92 92
Hardness, Rockwell C (converted from Brinell hardness, value below normal HRC range, for comparison purposes only) 13 13
Machinability (annealed and cold drawn. Based on 100% machinability for AISI 1212 steel) 55 55
Hits:  UpdateTime:2017-04-13 20:12:12  【Printing】  【Close
Previous:1.8159
Next:20Mn5